1. Introduction
Sometimes it may be
necessary to disconnect or reconnect the Bluetooth pairing between an
Inclinometer or HPG system and the Field PC.
If you cannot enter In-Port or
HPG-Port and the blue 'Comms Ready' light does not come on, the Bluetooth
connection would be the first thing to troubleshoot.
2. Disconnecting a
Bluetooth Pairing
To disconnect a
Bluetooth pairing, follow the procedure below:
Tap 'Settings', then 'Connections', then
'Bluetooth'
On the 'COM Ports' page, press and hold
the Inclinometer serial number you want to disconnect
When the menu appears, select 'Delete'
On the 'Devices' page, press and hold
the Inclinometer serial number you want to disconnect
When the menu appears, select 'Delete'
The Inclinometer Bluetooth pairing has
now been disconnected
3. Connecting a
Bluetooth Pairing
To connect a Bluetooth
pairing, follow the procedure below:
Make sure the Inclinometer or HPG you want to
connect to is powered on, is close to you, and that the blue 'Comms Ready'
light is not lit
Tap 'Settings', then 'Connections', then
'Bluetooth'
On the 'Devices' page, tap 'Add new
device...'
The Field PC will now search for the
Inclinometer, once it has found it, select the Inclinometer and tap 'Next'
The Field PC will now ask you to enter a
passcode, do not enter anything into the box, instead, tap 'Next'
The Field PC will now ask if you wish to
connect to the device, tap 'Yes'
The Field PC will once again ask for a
passcode, this time, enter '0' into the box and tap 'Next'
The Field PC will confirm the
Inclinometer has been connected, it should now appear on the 'Devices'
page
On the 'COM Ports' page, tap 'New
Outgoing Port'
Select the Inclinometer you wish to
connect to and tap 'Next'
Select 'COM9' from the drop-down list
and make sure 'Secure Connection' is not crossed, tap 'Finish'
Your Inclinometer or HPG and Field PC should now
be fully connected